PRE-RELEASE
Speed, lead from ABS
| Speed, lead from ABS |
The ABS control module sends a speed signal to pin 64 of the Trionic T7 control module. The signal is a square wave that varies between 0 V and B+ 29 times per wheel rotation. This speed signal is used to:
| • |
prevent adaptation of idle speed control when the car is moving.
|
|
| • |
on manual gearboxes, determine which gear is currently being used. This makes it possible to limit torque in gears R and 1 and activate fuel shut-off in gears 2, 3, 4 and 5. Control of the SHIFT UP lamp also depends on the current gear.
|
|
| • |
activate speed limitation by limiting the maximum air mass/combustion at 240 km/h.
|
|
| Diagnostics |
| • |
If there is no speed signal, diagnostic trouble code P0502 will be generated.
|
|
| • |
If the speed value is implausible, diagnostic trouble code P0501 will be generated.
|
|
System reaction to a fault
| • |
The speed (bus from MIU) is used as a substitute value.
|
|
| • |
Cruise control is blocked.
|
|
