PRE-RELEASE
Selector lever cable
| Selector lever cable |
| 1. |
Remove the battery cover, battery and battery tray.
|
|
| 2. |
Remove the gear selector arm from the gearbox. The selector lever must be in position L.
|
|
| 3. |
Remove the clamp at the cable bracket.
|
|
| 4. |
Remove the cable ferrule from the bracket on the transmission.
|
|
| 5. |
Remove the centre console, see group 8 Body, Climate control system, Interior equipment.
|
|
| 6. |
Remove the circlip and the anti-rattle clip.
|
|
| 7. |
Drive out the pin while removing the end of the cable from the ball.
|
|
| 8. |
Remove the screws securing the selector lever housing.
|
|
| 9. |
Unplug the selector lever housing's connector.
|
|
| 10. |
Lift up the selector lever housing and unplug the electrical connection from the ignition switch. Remove the air duct.
|
|
| 11. |
Remove the clamp located beside the locking catches.
|
|
| 12. |
Carefully press the catches securing the cable ferrule towards each other and remove the cable from the bracket.
|
|
| 13. |
Lift out the selector lever housing.
|
|
| 14. |
Pull the cable and rubber grommet into the car.
|
|||||||
| Fitting |
| 1. |
Fold aside the centre console's carpet beside the accelerator so that the cable's rubber grommet can be pressed into place.
|
|
| 2. |
Push the cable through the acoustic insulation from inside the cabin.
|
|
| 3. |
Lubricate the rubber grommet with vaseline and guide the cable to its correct position in the car.
|
|
| 4. |
Press the rubber grommet into the hole in the body metal.
|
|||||||
| 5. |
Connect the selector lever to the transmission and fit the clamp.
|
|
| 6. |
Fit the selector lever housing in place.
|
|
| 7. |
Connect the cable to the selector lever housing and fit the clamp.
|
|
| 8. |
Plug in the electrical connections to the ignition switch while putting the selector lever housing in place.
|
|
| 9. |
Connect the air duct and tighten the selector lever housing.
|
|
| 10. |
Tap in the pin at the same time as the ball enters the end of the cable.
|
|
| 11. |
Fit the circlip and the anti-rattle clip.
|
|
| 12. |
Fit the centre console, see group 8 Body, Climate control system, Interior equipment.
|
|
| 13. |
Fold back the carpet at the accelerator.
|
|
| 14. |
Adjust the position of the cable, see
.
|
|
| 15. |
Refit the battery tray, battery and battery cover.
|
|
| 16. |
Set the right time on the clock.
|
|
