PRE-RELEASE
Differential
| Differential |
| 1. |
Secure the differential in a vice with protective jaws and pull off the bearings with puller 87 92 343.
Use tool 87 91 659
as support.
|
|
To fit
| 1. |
Press down the bearings until they stop with press sleeve 87 92 475.
. Use tool 87 92 210 as support.
|
|
| 2. |
To change bearing race, see
|
|
| Replacement of final drive gear |
To remove
| 1. |
Remove the final drive gear bolts using an external torx and tap off the final drive gear using a plastic hammer.
|
|
To fit
| 1. |
Tap on the final gear wheel on the differential housing using a plastic hammer.
|
|
| 2. |
Fit the final drive gear with the mark towards the differential housing. Fit
new bolts
and tighten alternately. Coat the bolts with
Thread locking adhesive, Loctite 270
. It may be necessary to heat the gear before assembling.
Tightening torque 20 Nm+90° (15 lbf ft+90°) |
|
