PRE-RELEASE
Sealing ring - selector rod in car, VIN - 43501882
| Sealing ring - selector rod in car, VIN - 43501882 |
| 1. |
Wash the gearbox beside the gear selector shaft, engage 4th gear and fit locking pin 87 92 335.
|
|
| 2. |
Undo the M8 bolt on the selector rod and move the gear lever to 3rd.
|
|
| 3. |
Prise out the seal using a narrow screwdriver.
|
||||||||||
| To fit |
| 1. |
Clean the selector rod and check that it has no burrs.
|
|
| 2. |
Wind a layer of thin, smooth plastic tape around the hole in the selector rod.
|
|
| 3. |
Lubricate the gear selector rod and fit the seal. Remove the tape and tap in the seal using the
Assembly tool, sealing ring gear selector shaft
87 90 685 and
Clamp
87 91 709. Tap only as far as the seal is flush with the clutch housing.
|
|
| 4. |
Join the selector rods using the M8 bolt.
|
|
| 5. |
Check the oil level in the gearbox and top up if needed. Use
Assembly tool
87 92 590.
|
|
