ABS, TCS and ESP unit with control module
|
|
ABS, TCS and ESP unit with control module
|
|
1.
|
Place a cover over the splash guard to protect it from any brake-fluid spillage.
|
|
2.
|
Remove the battery cover and the battery.
|
|
3.
|
V6 diesel engine:
Remove the turbocharger heat shield.
|
|
4.
|
Detach the electrical distribution unit and place to one side.
|
|
5.
|
Unplug the connector and place to one side.
|
|
6.
|
ESP unit:
Unplug the connector from the pressure sensor.
|
|
7.
|
Use compressed air to clean the surfaces around the brake-pipe couplings.
|
|
8.
|
Dismantle the brake pipe couplings.
|
|
9.
|
LHD, manual gearbox:
Detach the clutch fluid hose from the brake fluid reservoir, collect the brake fluid.
|
|
10.
|
Remove the unit.
It may be necessary to insert a screwdriver between the bracket and the wheel housing and prise carefully in order to reach the outer nut.
|
|
1.
|
Fit the unit
It may be necessary to insert a screwdriver between the bracket and the wheel housing and prise carefully in order to fit the outer nut.
|
|
2.
|
ESP unit
Plug in the connector for the pressure sensor.
|
|
3.
|
Remove the plugs and fit the brake pipes. Tighten the brake pipe unions by hand first and then with a spanner.
|
Note
|
|
Start with the rear brake pipes and tighten one union before starting with the next.
|
Tightening torque 16 Nm (12 lbf ft)
|
|
4.
|
LHD, manual gearbox:
Attach the clutch fluid hose to the brake fluid reservoir.
Fit the hose clip upwards.
|
|
5.
|
Plug in the connector.
|
|
6.
|
Fit the electrical distribution unit.
|
|
7.
|
V6 diesel engine:
Fit the turbocharger heat shield.
|
|
8.
|
Fit the battery and the battery cover.
|
