PRE-RELEASE
Swinging caliper, rear wheel, changing
| Swinging caliper, rear wheel, changing |
| 1. |
Raise the car and remove the wheel.
|
|
| 2. |
Remove the brake pads.
|
|
| 3. |
Depress the brake pedal slightly, using a brake pedal clamp.
|
|
| 4. |
Remove fuse No. 1 for the brake lights.
|
|
| 5. |
Remove the clip from the brake pipe.
|
|
| 6. |
Remove the hose from the brake pipe and plug the pipe.
|
|
| 7. |
Remove the dust caps and the two brake caliper guide pins and lift away the hydraulic body.
|
|
| 8. |
Detach the brake hose connection from the brake caliper.
|
|
| To fit |
| 1. |
Remove the plugs and connect the brake lines.
Tightening torque 43 Nm (32 lbf ft) |
|
| 2. |
Fit the hydraulic body and tighten its two guide pins to torque.
Tightening torque 28 Nm (21 lbf ft) |
|
| 3. |
Fit the brake hose to the pipe
|
|
| 4. |
Fit the clip.
Fit the brake pads. |
||||||||||
| 5. |
Lower the car slightly, remove the brake pedal clamp and put the fuse back in its holder.
|
|
| 6. |
Bleed the brake system, see
Bleeding the brake system
.
|
|
| 7. |
Fit the rear wheel, see
Wheels
.
Tightening torques aluminium wheel 110 Nm (81 lbf ft) steel wheel 50 Nm +2x90°, max. 110 Nm (37 lbf ft +2x90°, max. 81 lbf ft) |
|
| 8. |
Lower the car to the floor and depress the brake pedal to force out the brake pistons.
|
|
| 9. |
Check the brake fluid level and top up as necessary.
|
|
