PRE-RELEASE
Handbrake cable
| Handbrake cable |
| 1. |
Release the handbrake.
|
|
| 2. |
Raise the car.
|
|
| 3. |
Separate the front and rear exhaust pipe sections.
|
|
| 4. |
Remove the left-hand rubber exhaust-pipe suspension block.
|
|
| 5. |
Undo the heat shield's two rear retaining nuts on the left-hand side.
|
|
| 6. |
Bend the heat shield downwards by a sufficient amount to gain access to the cable equalizer.
|
|
| 7. |
Remove the return springs and unhook the cables from the actuating levers.
|
|
| 8. |
Turn the pull cable 90° and separate the cable equalizer.
|
|
| 9. |
Pull the cable out of the front cable holder and lift out the cable.
|
|
| 10. |
Support the fuel tank with a single-pillar jack.
|
|
| 11. |
Undo the tank straps at the front and withdraw the cable.
|
|
| To fit |
| 1. |
Correctly position the cables under the tank and tighten the tank straps.
|
|
| 2. |
Insert the pull cable into the cable equalizer and turn it 90°.
|
|
| 3. |
Lift the cable into the front and rear holders.
|
|
| 4. |
Hook the cables in place and fit the return springs.
|
|
| 5. |
Press the heat shield up into place and secure it.
|
|
| 6. |
Fit the exhaust pipe's rubber suspension block.
|
|
| 7. |
Fit the front and rear exhaust pipe sections together.
|
|
| 8. |
Adjust the handbrake, see
.
|
|
