PRE-RELEASE
Control module
| Control module |
The ESP function reduces engine torque and handle the braking on all four wheels. Torque reduction takes place after the ESP control module sends a bus message requesting a certain engine torque. The engine control module uses this request to regulate the air mass/combustion.
The ESP system utilises the TCS function to a high degree, which means that ESP normally starts to function using Traction Control. If further action is required, it will be handled individually by braking the wheels until the car becomes stable again.
The stabilising effect of the ESP system is based on calculations performed by the control module's microprocessor. The control module evaluates information from the system sensors: wheel speed sensors, steering wheel angle sensor, yaw rate sensor, lateral acceleration sensor and pressure sensor. Data from these sensors informs the control module of the driver's intentions, e.g. in which direction the driver wishes to drive, if the driver is braking, etc.
These values are processed by the control module. The control module also continually calculates the course of the car, the actual value, and compares this with desired direction indicated by the steering wheel, the desired value.
| • |
If the car starts to understeer (when the front tends to continue straight ahead in a bend), the brakes will be applied on the inside rear wheel.
|
|
| • |
If the car starts to oversteer (the rear tends to drift out), the system will apply the brakes on the outside wheels until the measured and the calculated yaw rates correspond.
|
|
The control module contains a main relay and pump relay
Main relay
The integral main relay supplies power to the solenoid valves and pump relay and cannot be replaced separately.Pump relay
The integral pump relay supplies power to the return pump and cannot be replaced separately.| Programming |
The ESP control module automatically reads all the information concerning the engine and transmission from DICE. Tech 2 is used to program the chassis variant, sport or standard.
| Diagnostics |
The control module monitors its own internal functions as well as the components included in the system. A DTC will be generated in the event of an internal control module fault. The ESP, TCS and ABS functions will be disengaged and the warning lamps for the ABS, foot brake, central warning lamp and ESP OFF switched on.
