Evaporator temperature sensor
|
|
Evaporator temperature sensor
|
|
1.
|
Remove the glove box. See
Glove box
.
Remove the trim from the side of the centre console.
|
|
2.
|
Cut the cable tie holding the wire harness to the service cover. Also cut the cable tie holding the cooler hose to the glove box.
Remove the service cover.
|
|
3.
|
Remove the fresh-air filter.
|
|
4.
|
Put a hand into the filter holder and carefully pull out the temperature sensor from the evaporator.
|
|
5.
|
Separate the connector and detach contact from the plate.
Lift up the plate and unplug the contact.
|
|
1.
|
Locate the temperature sensor in the old hole in the evaporator.
Place the lead's grommet in the groove by the upper fin.
|
|
2.
|
Fit the fresh-air filter. Refer to
Particle filter
when changing the filter.
|
|
3.
|
Fit the temperature sensor from behind the plate. Plug the connector to the car's wiring harness.
|
|
4.
|
Fit the service cover.
Fasten the wiring harness and cooler hose with cable ties. To ensure tightness, check that the lead's rubber grommet is located correctly.
|
|
5.
|
Replace the side trim on the centre console.
Fit the glove box. See
Glove box
.
|
