PRE-RELEASE
Rear crankshaft seal
| Rear crankshaft seal |
| 1. |
Remove the gearbox, see
To remove
.
|
|
| 2. |
Remove the pressure plate and clutch plate, see
Changing clutch assembly
.
|
|
| 3. |
Remove the flywheel.
|
|
| 4. |
Screw in a self-tapping screw and pull out the seal.
|
|
| To fit |
| 1. |
Clean any gasket remains from the sealing surfaces.
|
|
| 2. |
Lubricate the new seal with non-acidic Vaseline and position it on
83 95 402 Assembly tool, rear crankshaft seal
(KM-934-1).
|
|
| 3. |
Position the seal on the crankshaft with
83 95 402 Assembly tool, rear crankshaft seal
. Press in the seal with the tool until it is flush with the cylinder block.
|
|
| 4. |
Fit the flywheel with new bolts. Use
83 94 868 Flywheel locking attachment
for support.
Tightening torque: 45 Nm (33 lbf ft) + 30°. |
|
| 5. |
Fit the pressure plate and clutch plate, see
Changing clutch assembly
.
|
|
| 6. |
Fit the gearbox, see
To fit
.
|
|
