PRE-RELEASE
Front silencer
| Front silencer |
| To remove |
| 1. |
Raise the car.
|
|
| 2. |
Loosen the nuts at the joint between the front and rear of the exhaust system.
|
|
| 3. |
Remove the rubber mounting lock clips.
|
|
| 4. |
Remove the two front rubber mountings and place, for example, the jack of the lift under the end of the pipe.
|
|
| 5. |
Remove the remaining rubber mounts and lower the exhaust system.
|
|
| Note | ||
|
If the system is divided before the last silencer, loosen the exhaust clamp of the rear silencer and divided the system there. |
| To fit |
| Note | ||
|
The rubber mountings can be lubricated with acid-free petroleum jelly to facilitate fitting. |
| 1. |
Fit the rubber mountings, lift up the exhaust system and fit it in place. Adjust the system so that it does not break/buckle or lie against anything.
For cars with visible tailpipe: adjust so that the tailpipe is centred in the cut-out. |
|
| 2. |
Fit the rubber mounting lock clips.
|
|
| 3. |
Fit the nuts at the joint between the front and rear of the exhaust system.
Tightening torque: 22 Nm (16 lbf ft) |
|
