SAAB WIS ONLINE

PRE-RELEASE

Injection pipe/Fuel rail, V6

Injection pipe/Fuel rail, V6

To remove

Warning

Removal of the fuel rail involves partial dismantling of the car's fuel system. The following points must therefore be observed in connection with this work:

• Make sure a class BE fire extinguisher is close to hand! Consider the risk of sparking, e.g. when breaking circuits, short-circuits etc.

• Absolutely No Smoking!

• Ensure that there is a good exchange of air. If approved ventilation for the extraction of fuel fumes is available, this should be used.

• Wear protective gloves! Prolonged exposure of the hands to fuel can cause irritation to the skin.

• Wear protective goggles.


Important

Be particulary observant regardning cleanliness when working on the fuel system. Loss of function may occur due to very small particles. Prevent dirt and grime from entering the fuel system by cleaning the connections and plugging pipes and lines during disassembly. Use 82 92 948 Plugs, A/C system assembly. Keep components free from contaminants during storage.



1. Remove the intake pipe from the mass air flow sensor and turbocharger.


2. Remove the upper engine cover.

3. Unplug the connectors, remove the front cable rail and bend aside the engine harness.


4. Remove the upper intake manifold and the turbocharger's bracket.

Warning

Release the pressure in the fuel system before starting work. Cover the fuel connections with a rag to protect against spurting fuel.


5. Remove the fuel pipes and fuel rail.



To fit


1. Fit the fuel rail and fuel pipes. Make sure the protective sleeve on the connector is correctly fitted.


Fuel rail tightening torque 25 Nm (19 lbf ft)

2. Fit the bracket for the turbocharger.

3. Fit the upper intake manifold with bracket and turbo pressure hose to the upper intake manifold using new seals.


Tightening torque 21 Nm (23 lbf ft)

4. Fit the engine harness.

5. Fit the upper engine cover and the intake pipe to the mass air flow sensor and turbocharger.

Tightening torque, mass air flow sensor: 3.5 Nm (2.5 lbf ft)



PRE-RELEASE