PRE-RELEASE
Courtesy lights
| Courtesy lights |
The courtesy lights are located on the bottom of the doors. If the ignition switch is OFF (key removed), the lights will go on if one or more doors are opened. Courtesy lights stay on for 20 minutes (if a door is kept open) and then go out automatically. The lights are turned off when the doors are closed.
If the ignition is ON (+15 or +54), the courtesy lights stay on until all the doors are closed.
+30 current is fed to DICE for the courtesy lights. When DICE has received information via the bus, it turns on or off the courtesy lights. In other words, +30 current is supplied or not supplied, as the case may be, to the courtesy lights from pin 1 on the control module.
| Diagnosis |
The output is provided with overload protection which shuts it off in the event of an excessive load. When this occurs, diagnostic trouble code B1240 will be generated.
DTCs are not generated if the voltage is below 11 V, or during diagnostic communication, or in case of interruption.
| Important | ||
|
All lamp outputs are protected by short-circuiting. |
||
|
Do not change to lamps of a higher wattage, since the outputs are not made to withstand a permanent overload. |
||
|
If the wattage goes unduly high the short-circuit protection will immediately trip. |
||
