PRE-RELEASE
Rear engine mounting
| Rear engine mounting |
| To remove |
| 1. |
Remove the battery cover and disconnect the negative battery cable.
|
|
| 2. |
Remove the upper intake manifold between the mass air flow sensor and the turbocharger.
|
|
| 3. |
Remove the upper engine cover.
|
|
| 4. |
Remove the gear linkage mounting from the rear engine mounting bracket.
|
|
| 5. |
Fit
83 94 850 Lifting beam
and take the weight off the engine.
|
|
| 6. |
Remove the nut from the right-hand engine mounting.
|
|
| 7. |
Remove the rear engine mounting lock nut.
|
|
| 8. |
Remove the bolts in the engine mounting and raise the car.
|
|
| 9. |
Remove the lower engine cover.
|
|
| 10. |
Remove the front bolt in the torque arm.
|
|
| 11. |
Remove the front exhaust pipe with bracket.
|
|
| 12. |
Remove the subframe rear bolts and the triangle plates. Place a
wedge
between the subframe mountings and the body.
|
|
| 13. |
Lower the car and raise the engine as high as possible using the lifting sling.
|
|
| 14. |
Raise the car and remove the rear engine mounting and mounting pad. Prise carefully between the subframe and the oil pan if there is not enough room.
|
|
| To fit |
| 1. |
Position the engine mounting and mounting pad. Prise carefully between the subframe and the oil pan if there is not enough room. Fit the mounting pad and insert the bolts.
|
|
| 2. |
Refit the engine mounting.
Tightening torque 60 Nm + 60° (44 lbf ft + 60°) |
|
| 3. |
Remove the wedge and fit the subframe bolts on both sides as well as the triangle plates.
Tightening torque, subframe 100 Nm + 45° (74 lbf ft + 45°) Tightening torque, triangle plates 63 Nm (46 lbf ft) 
|
|
| 4. |
Fit the front exhaust pipe with bracket.
|
|
| 5. |
Lower the car and tighten the mounting pad bolts.
Tightening torque 26 Nm (19 lbf ft) 
|
|
| 6. |
Lower the car and make sure the engine is positioned correctly on the mountings.
|
|
| 7. |
Remove the lifting beam and mount the nut for the right-hand engine mounting pad.
Tightening torque 105 Nm (77 lbf ft) 
|
|
| 8. |
Fit the lock nut on the rear engine mounting pad.
Tightening torque: 47 Nm (35 lbf ft) 
|
|
| 9. |
Fit the gear linkage mounting onto the engine mounting bracket.
Tightening torque Nm |
|
| 10. |
Raise the car and fit the front bolt on the torque arm and the nut on the charge air pipe.
Tightening torque, torque arm 90 Nm + 90° (66 lbf ft + 90°) 
|
|
| 11. |
Fit the lower engine cover.
|
|
| 12. |
Lower the car and fit the upper engine cover and the intake manifold between the mass air flow sensor and the turbocharger.
Tightening torque, mass air flow sensor: 3.5 Nm (2.5 lbf ft) 
|
|
| 13. |
Connect the negative battery terminal and fit the battery cover.
|
|
| 14. |
Set the car clock.
|
|
