PRE-RELEASE

Telescope cylinder, headlamp washers

To remove

1.	Remove the headlamp, see Headlamp .

2.	Remove the washer jet with associated check valve by pressing in the clip on both sides with two screwdrivers.

3.	Remove the bolts.

4.	Remove the bumper mounting bolt.

5.	Carefully press the bumper lugs out of the bumper member mounting.

6.	Lift the telescope cylinder up out of the bumper member.

7.	Detach the washer hose and remove the telescopic cylinder.

To fit

1.	Connect the washer hose.

2.	Position the telescope cylinder in the bumper member.

3.	Carefully press the bumper lugs into of the bumper member mounting.

4.	Fit the bumper mounting bolt.

5.	Fit the telescopic cylinder with the screws.

6.	Fit the clip to the washer nozzle.

7.	Fit the washer nozzle to the telescope cylinder. Important Check that the clip locks correctly. If not, use a new clip.

8.	Fit the headlamp, see Headlamp .

PRE-RELEASE

This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.

Our Friends