PRE-RELEASE
Clutch delivery pipe LHD
| Clutch delivery pipe LHD |
| To remove |
| 1. |
Place a cover over the splash guard to protect it from any brake fluid spillage.
|
|
| 2. |
Remove the battery cover and the battery.
|
|
| 3. |
(V6 diesel) Remove the turbocharger heat shield.
|
|
| 4. |
Disconnect the electrical distribution unit and move it aside.
|
|
| 5. |
Drain the clutch system using
brake bleeder
88 19 096. Suck out the brake fluid through the bleed nipple.
|
|
| 6. |
Disconnect the supply hose from the brake fluid reservoir.
|
|
| 7. |
Disconnect the connector from the ABS unit and place it to one side.
|
|
| 8. |
Clean around the brake pipe connections using compressed air.
|
|
| 9. |
Disconnect the brake pipes and plug the holes.
|
|
| 10. |
Remove the ABS unit.
It may be necessary to insert a screwdriver between the bracket and the wheel housing and prise carefully in order to reach the outer nut. |
|
| 11. |
Remove the ABS unit bracket.
|
|
| 12. |
Undo the clip securing the delivery pipe to the master cylinder.
|
|
| 13. |
Detach the delivery pipe from the master cylinder. Fit the clip.
|
|
| 14. |
Remove the clip securing the delivery pipe to the slave cylinder.
|
|
| 15. |
Remove the delivery pipe (along with accumulator, diesel only).
|
|
| To fit |
| 1. |
Make sure that the clips are fitted.
|
|
| 2. |
Place the delivery pipe in position and connect it to the slave cylinder and master cylinder.
|
|
| 3. |
Press the pipe into the plastic clip.
|
|
| 4. |
Fit the ABS unit bracket.
|
|
| 5. |
Fit the ABS unit and plug in the connector.
|
|
| 6. |
Remove the plugs and connect the brake pipes.
|
|
| 7. |
Connect the supply hose to the brake fluid reservoir. Point the hose clip upwards.
|
|
| 8. |
Fill the system with brake fluid and bleed as described under
Bleeding the clutch hydraulic system in the car
.
|
|
| 9. |
Bleed the brake system, see
Bleeding the brake system
|
|
| 10. |
Check that the connections are sealed.
|
|
| 11. |
Fit the electrical distribution unit.
|
|
| 12. |
(V6 diesel) Fit the turbocharger heat shield.
|
|
| 13. |
Fit the battery and battery cover.
|
|
| 14. |
Test the clutch and brakes.
|
|
| 15. |
Remove the splash guard cover.
|
|
| 16. |
Set the car's clock.
|
|
