PRE-RELEASE
Master cylinder, RHD
| Master cylinder, RHD |
| To remove |
| 1. |
V6 TiD:
Remove the upper intake manifold.
|
|
| 2. |
V6 TiD:
Remove the upper engine cover.
|
|
| 3. |
Drain the brake fluid reservoir. Use
88 19 096 Bleeding equipment
. Then connect the brake bleeder to the bleed nipple on each front brake caliper and draw out the remaining brake fluid.
If changing the master cylinder: Remove the brake fluid reservoir, see Brake fluid reservoir, RHD . |
|
| 4. |
Disconnect the brake pipes and plug them.
|
|
| 5. |
Remove the two master cylinder retaining nuts and lift out the master cylinder.
|
|
| To fit |
| 1. |
Fit the two master cylinder retaining nuts.
Tightening torque: 25 Nm (18 lbf ft) 
|
|
| 2. |
Connect the brake pipes. Make sure the pipes are positioned correctly in their clips.
Tightening torque: 16 Nm (12 lbf ft) |
|
| 3. |
If the master cylinder has been changed:
Fit the brake fluid reservoir, see
To fit
.
|
|
| 4. |
V6 TiD:
Fit the upper engine cover.
|
|
| 5. |
V6 TiD:
Fit the upper intake manifold.
|
|
| 6. |
Bleed the brake system, see
Bleeding the brake system
.
|
|
