PRE-RELEASE
Anti-roll bar
| Anti-roll bar |
| 1. |
Remove the cover over the intake manifold.
|
|
| 2. |
Remove the engine cushion from the engine mounting and subframe.
|
|
| 3. |
Position lifting beam 83 94 850 on the wings and fit the hook in the engine's rear lifting eyebolt.
|
|
| 4. |
Raise the car and remove the front wheels.
|
|
| 5. |
Remove the reinforcement at the subframe's rear mounting point.
|
|
| 6. |
Pull the joint between the catalytic converter and silencer apart.
|
|
| 7. |
Remove the two steering gear retaining bolts.
|
|
| 8. |
Remove the bolts from the subframe's centre attachment point and lower the rear of the subframe.
|
|
| 9. |
Detach the anti-roll bar from the links.
|
|
| 10. |
Remove the bolts from the clamps securing the anti-roll bar to the subframe.
|
|
| 11. |
Withdraw the anti-roll bar through the wheel housing on the passenger's side.
|
|
| To fit |
| 1. |
Lift the anti-roll bar into position through the wheel housing on the passenger's side. Make sure that it does not catch on any hoses or cables in the engine bay.
|
|
| 2. |
Lubricate the bushes with Molycote 33 and fit them with the opening facing rearwards.
|
|
| 3. |
Tighten the bolts in the clamps securing the anti-roll bar to the subframe.
Tightening torque 25 Nm (20 lbf ft) |
|
| 4. |
Tighten the nuts securing the anti-roll bar to the links.
Tightening torque 90 Nm (65 lbf ft) |
|
| 5. |
Raise the subframe and tighten the bolts at the centre attachment points.
Tightening torque 100 Nm +45° (75 lbf ft +45°) . |
|
| 6. |
Close the joint between the catalytic converter and silencer.
|
|
| 7. |
Fasten the subframe at its rear attachment points together with the reinforcement.
Tightening torque 100 Nm +45° (75 lbf ft +45°) . |
|
| 8. |
Tighten the bolts securing the reinforcement to the subframe.
Tightening torque 65 Nm (50 lbf ft) |
|
| 9. |
Tighten the steering gear's retaining bolts.
Tightening torque 95 Nm (70 lbf ft) |
|
| 10. |
Fit the wheels, see
Wheels
.
Tightening torques aluminium rim 110 Nm (81 lbf ft) pressed steel rim 50 Nm +2x90°, max. 110 Nm (37 lbf ft +2x90°, max. 81 lbf ft) Lower the car to the floor. |
|
| 11. |
Lower the engine onto the rear engine cushion and remove the lifting beam.
|
|
| 12. |
Tighten the bolts securing the engine cushion to the subframe.
Tightening torque 25 Nm (20 lbf ft) |
|
| 13. |
Tighten the bolts securing the rear engine cushion to the engine mounting.
Tightening torque 50 Nm (35 lbf ft) |
|
| 14. |
Refit the cover over the intake manifold.
|
|
