PRE-RELEASE
Rear bumper, 4D
| Rear bumper, 4D |
| 1. |
Undo the screws in the wheel housing, 2 on each side.
|
|
| 2. |
Open the boot lid.
|
|
| 3. |
Remove the scuff plate.
|
|
| 4. |
Fold away the luggage compartment carpet and remove the seals. The old seals must be discarded and replaced by new ones.
|
|
| 5. |
Remove the nuts holding the bumper.
|
|
| 6. |
Together with an assistant, pull out the bumper from the clips and lift the bumper out backwards.
|
|||||||||||||||||||
| To fit |
| Note | ||
|
For cars equipped with Saab Parking Assistance (SPA): |
||
| • |
Attach the connectors.
|
|
| 1. |
Place the bumper in position and press it over the edge of the wheel housing and the rear wing. Make sure that the clips sit correctly.
|
|
| 2. |
Put the nuts in place.
|
|
| 3. |
Position the bumper correctly and tighten the screws in the edge of the wheel housing.
|
|
| 4. |
Tighten the nuts.
|
|
| 5. |
Fit new seals and fold down the luggage compartment carpet.
|
|
| 6. |
Fit the scuff plate.
|
|
| 7. |
Fit the luggage compartment carpet.
|
|
| 8. |
Close the boot lid and check the bumper fit.
|
|
