SAAB WIS ONLINE

PRE-RELEASE

MIG brazing equipment

MIG brazing equipment


Some weld seams on the Saab 9-3 (9440) CV has a new type of seam with bronze wire, known as MIG brazing. The affected areas are the sill, windscreen frame and at the A-pillars. MIG brazing can be identified by its gold colour.

In the event of sheet metal damage in an area with MIG brazing, a new method must be used that requires a new type of equipment.

Depending on the equipment and the sheet metal thickness, different welding equipment settings are required. These are known as welding parameters.



Ensure that independent workshops have parameters for the localised areas as well as the relevant method from WIS. In all cases, pure argon gas is to be used and the welding wire must be 1 mm.

Warning

MIG brazing is not to be repaired using a conventional welding method or standard filler. Cracks could form, which would impair impact characteristics.


The following equipment is approved for MIG brazing:


• Cloos GLC 353 MC3 with CK 98 A

Reference no.: OP 510402

Internet address: www.cloose.de

• ELMATech MIDI - MIG 300/800

Reference no.: SA.20268.1

Internet address: www.elmatech-aq.com

• Fronius TPS2700 4R/E

Reference no.: TPS2700 4R/E

Internet address: www.fronius.com

• Kemppi Pro 3200 EVO with Promig 530 incl. MXE - Panel

Reference no.: PROMIG 3200 OPEL

Internet address: www.kemppi.com

• Migatronic Flex 3000 XMI-L with MWF 15/CMI3000

Reference no.: 79541063 Version GM

Internet address: www.migatronic.com

www.car-o-liner.se

• Wielander & Schill InvertaPuls IP 10 Digital

Reference no.: 331010

Internet address: www.wielanderschill.com

• MIDI-MIG 300/800

Internet address: www.celette.com


PRE-RELEASE