Clutch pedal switch
| Clutch pedal switch |
| To remove |
| 1. |
Remove the pedal bracket cover by undoing the 3 screws and the clip. Tilt the cover and carefully pull it out. Pay attention to the cables for the diagnostic tool data link connector and the lighting.
|
|
| 2. |
Depress the clutch pedal.
|
|
| 3. |
Extract the red sleeve on the switch until it clicks.
|
|
| 4. |
Detach the switch by pressing in the catches with an electricians screwdriver or similar tool.
|
|
| 5. |
Unplug the connector once the switch is loose.
|
|
| To fit |
| 1. |
Spray the connector with Kontakt 61 (part no. 30 04 520).
|
|
| 2. |
Make sure the switch is fully extracted.
|
|
| 3. |
Depress the clutch pedal and press the switch into the holder.
|
|
| 4. |
Carefully release the pedal.
|
|
| 5. |
Plug in the connector.
|
|
| 6. |
Fit the pedal bracket cover with 3 screws and 1 clip.
|
|
This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.
Our Friends
