PRE-RELEASE
Bonnet lock
| Bonnet lock |
| 1. |
Open the bonnet and remove the grille.
|
|
| 2. |
Undo the screws in the cable stop and pull the wire out of its sleeve and the lock levers. Retain the cable stop.
|
|
| 3. |
Unscrew the lock and remove it.
|
|
| To fit |
| 1. |
Fit the bonnet lock without tightening the retaining screws.
|
|
| 2. |
Carefully close the bonnet so that the lock centres on the locking pin. Tighten the screws.
Tightening torque: 10 Nm (7 lbf ft) |
|
| 3. |
Insert the wire into one of the lock springs and fit the cable stop.
|
|
| 4. |
Insert the wire into the sleeve and the other lock spring. Fit the cable stop.
|
|
| 5. |
Make sure the spring is positioned against the stop (A) when released and that there is clearance between the cable stop and the spring.
|
|||||||
| 6. |
Adjust the bonnet and check its function.
|
|
