PRE-RELEASE
Fan motor, backrest
| Fan motor, backrest |
| 1. |
Take the front seat out of the car, see
.
|
|
| 2. |
Undo the straps holding the backrest upholstery at the bottom.
|
|
| 3. |
Release the upholstery strips on the underside.
|
|
| 4. |
Undo the cables and cut the cable ties. Extract the cables from the hole.
|
|
| 5. |
Pull out the sheet from the pocket.
Undo the rear of the backrest upholstery by releasing the upholstery strips along the sides and folding back the upholstery. |
|
| 6. |
Detach the backrest fan, 2 spacer sleeves and 2 nuts.
|
|
| 7. |
Unplug the connector under the seat and cut the cable ties.
Lift out the fan motor. |
|
| To fit |
| 1. |
Fit the fan motor in the backrest, 2 nuts and 2 spacer sleeves.
|
|
| 2. |
Plug in the connector for the fan motor under the seat. Secure with cable ties.
|
|
| 3. |
Refit the back of the backrest upholstery by replacing the upholstery strips along the sides.
|
|
| 4. |
Insert the sheet into the backrest upholstery.
|
|
| 5. |
Insert the cables and connect them. Fit new cable ties.
|
|
| 6. |
Replace the upholstery strips on the underside.
|
|
| 7. |
Fasten the straps on the bottom of the backrest upholstery under the seat cushion.
|
|
| 8. |
Refit the front seat into the car, see
.
|
|
