PRE-RELEASE
Rear seat backrest, 5D
| Rear seat backrest, 5D |
| 1. |
Fold forward the rear seat cushions.
|
|
| 2. |
Fasten the rear seat belts on the belt holders on the C-pillars.
|
|
| 3. |
Fold forward the 40% backrest slightly and undo the upholstery clip.
|
|
| 4. |
Release the catch by the sill with a screwdriver and lift off the backrest (upwards).
|
|
| 5. |
Pull away the backrest from the hinge pin by the centre joint and lift out the backrest.
|
|
| 6. |
Remove the centre seat belt lower mounting.
|
|
| 7. |
Remove the hinge pin by the centre joint.
|
||||||||||
| 8. |
Undo the upholstery clip on the 60% backrest.
|
|
| 9. |
Raise the backrest to the upright position. Lift off the backrest from the LH side mounting.
|
|
| 10. |
Slide the 60% backrest towards the door to extract the centre joint locking pin from its hole.
|
|
| 11. |
Lift out the backrest.
|
|
| To fit |
| 1. |
Lift in the 60% backrest.
|
|
| 2. |
Move the centre belt buckle out of the way. Position the pin in the relevant hole in the centre joint.
|
|
| 3. |
Lower the backrest vertically over the side mounting.
|
|
| 4. |
Hook on the 60% backrest upholstery clip.
|
|
| 5. |
Fit the hinge pin by the centre joint.
Tightening torque: 24 Nm (17.6 lbf ft)
|
||||||||||
| 6. |
Lift in the 40% backrest and position it against the hinge pin by the centre joint.
|
|
| 7. |
Press down the backrest to the side mounting, making sure the catch locks properly.
|
|
| 8. |
Hook on the upholstery clip.
|
|
| 9. |
Press back the backrest to engage the upper locks.
Check the function. |
|
| 10. |
Fit the centre seat belt lower mounting.
Tightening torque: 45 Nm (33 lbf ft) |
|
| 11. |
Fold back the rear seat cushions.
|
|
