PRE-RELEASE
Particle filter/rear catalytic converter
| Particle filter/rear catalytic converter |
| To remove |
| 1. |
Undo the clamp and remove the rear exhaust system.
|
|
| 2. |
Detach the hose for pressure drop measurement from the particle filter/rear catalytic converter.
|
||||||||||
| 3. |
Remove the temperature sensor (602R).
|
|
| 4. |
Remove the three nuts connecting the particle filter/rear catalytic converter to the front exhaust pipe.
|
|
| 5. |
Remove the rear mounting of the particle filter/rear catalytic converter from the body and lower the particle filter/rear catalytic converter.
|
|
| 6. |
Remove the mounting from the particle filter/rear catalytic converter.
|
|
| To fit |
| 1. |
Fit the mounting to the particle filter/rear catalytic converter.
|
|
| 2. |
Position the particle filter/rear catalytic converter and use a new gasket. Fit the rear mounting to the body.
|
|
| 3. |
Fit the three nuts connecting the particle filter/rear catalytic converter to the front exhaust pipe.
Tightening torque: 25 Nm (18 lbf ft)
|
||||||||||
| 4. |
Lubricate the temperature sensor threads with
90 513 210 Universal paste
and fit the temperature sensor.
Tightening torque: 45 Nm (33 lbf ft) |
|
| 5. |
Attach the hose for pressure drop measurement to the particle filter/rear catalytic converter. Check that the protective sleeve covers the connection.
|
|
| 6. |
Fit the rear exhaust system and tighten the clamp.
|
|
| 7. |
If a new catalytic converter has been fitted
: Connect the diagnostic tool to restore adaptation values.
|
|
