SAAB WIS ONLINE

PRE-RELEASE

Rear exhaust gas temperature sensor (602R)

Rear exhaust gas temperature sensor (602R)

To remove


1. Remove the upper engine cover and insulation.

2. Unplug the temperature sensor connector.


Important

Take care when releasing the locking mechanism on the connector so as not to damage the connector. Pull the halves straight apart to avoid bending the pins. For further information regarding connectors, refer to Connectors, handling and inspection .


3. Undo the connector from the bracket and the cable from its upper fixings.

4. Lower the cable.

5. Raise the car.

6. Undo the lower fixings and remove the temperature sensor from the particle filter.



To fit


1. Lubricate the threads sparingly with 90 513 210 Universal paste and fit the temperature sensor.

Tightening torque: 45 Nm (33 lbf ft)


2. Reposition and secure the cable.

3. Lower the car to the floor.

4. Secure the cable and fit the connector to the bracket.


5. Plug in the temperature sensor connector.

Important

Take care when plugging in the connector so as not to damage or press out the pins/sleeves in the connector. For further information regarding connectors, refer to Connectors, handling and inspection .


6. Fit the insulation and upper engine cover.


PRE-RELEASE