PRE-RELEASE
Engine mounting, left
| Engine mounting, left |
To remove
| 1. |
Cover the wings and remove the cover over the battery. Note the radio code where applicable. Remove the top engine cover.
|
|
| 2. |
Detach the battery and battery tray. Loosen the fuse box and move it to the side.
|
|
| 3. |
Relieve the weight on the engine with
83 94 850 Lifting beam
.
|
|
| 4. |
Undo the centre nut and bolts on the engine pad.
|
|
| 5. |
Remove the engine mounting (and the steady bar's screw, manual only).
|
|
| 6. |
Detach the clutch hydraulic hose from its fastening.
|
|
| 7. |
Remove the engine mounting.
|
|
To fit
| 1. |
Fit the engine mounting (and brace screw, manual only).
Tightening torque, man. 47 Nm (35 lbf ft) Tightening torque, aut. 84 Nm (62 lbf ft) Tightening torque, engine mounting brace 63 Nm (46 lbf ft) |
|
| 2. |
Fit the clutch hydraulic hose to its fastening.
|
|
| 3. |
Fit the engine pad locating bolt and make sure the centre bolt is in the centre of the engine pad without being pulled to one side.
|
|
| 4. |
Tighten the remaining bolts and the centre nut
Tightening torque bolts 40 Nm +45° (35 lbf ft +45°) Tightening torque, nut, up to and including Vehicle Identification Number 73514478: 84 Nm (62 lbf ft) Tightening torque, nut, from and including Vehicle Identification Number 73514479: 74 Nm (55 lbf ft) |
|
| 5. |
Take the weight off the engine and remove the lifting beam.
|
|
| 6. |
Replace the fuse box, battery and battery tray.
Set the correct time on the clock. Calibrate the ACC. 
|
|
