PRE-RELEASE

Glow plug (398), Z19

To remove

Remove the engine cover and insulation.

Unplug the connector.

Important
Take care when releasing the locking mechanism on the connector so as not to damage the connector. Pull the halves straight apart to avoid bending the pins. For further information regarding connectors, refer to Connectors, handling and inspection .

Blow clean around the glow plugs. Undo and remove them using a 9 mm deep socket.

To fit

Fit the glow plug. Use a 9 mm deep socket.

Tightening torque: 10 Nm (7 lbf ft)

Plug in the connector.

Important
Take care when plugging in the connector so as not to damage or press out the pins/sleeves in the connector. For further information regarding connectors, refer to Connectors, handling and inspection .

Fit the insulation and engine cover.