PRE-RELEASE

"Activate" menu

/ 9-5 (9600) / 2008 / 2. Engine / Engine management system EDC 16 / Fault diagnosis, general / "Activate" menu

"Activate" menu

Activate	Information
Glow Request	Activation command sent to the glow plug control module.
Fuel Preheater	Processor control of the transistor that grounds the relay circuit.
AC Relay	Processor control of the transistor that grounds the relay circuit.
Fan Control Output 1	Processor control of the transistor that grounds the relay circuit.
Fan Control Output 2	Processor control of the transistor that grounds the relay circuit.
Fan Control Output 3	Processor control of the transistor that grounds the relay circuit.
Swirl Control Valve	Activation command sent to the actuator.
EGR Control Valve	Activation command sent to the actuator.
Throttle Actuator	Activation command sent to the actuator.
Charge Air Control Valve	Activation command sent to the actuator.
Idle Speed
Particle Filter Regeneration	Special application forcing the regeneration of the particle filter

Adjustments	Information
Starting Torque	The engine's start torque can be adjusted. The setting influence fuel consumption at start up.
Fuel Quantity Adjustment	The engine's torque can be adjusted. The setting influence fuel consumption during driving.
EGR adjustments	The engine's EGR flow can be adjusted.
Idle Speed	The engine's idling speed can be adjusted, such as to avoid vibrations.

Programming	Information
Injector Replaced	Programming must be performed if this component is changed. The injector classification is loaded into the control module to ensure correct functionality.
Fuel Pressure Sensor Replaced	Programming must be performed if this component is changed. Resets the adaptation value in the control module.
Particle Filter Replaced	Programming must be performed if this component is changed. Resets the adaptation value in the control module.
Particle Filt. Pressure Sens. Repl	Programming must be performed if this component is changed. Resets the adaptation value in the control module.
Pre Catalyst Replaced	Programming must be performed if this component is changed. Resets the adaptation value in the control module.
Spare Part Programming	Programming must be performed if the control module is changed.

PRE-RELEASE