SAAB WIS ONLINE

PRE-RELEASE

Test readings, control module connections

Test readings, control module connections




Scope

Nominal values and instructions for measuring voltages on the control module can be found under the respective headings below.

Remember:


Note the test conditions and use common sense when assessing the test result.

The nominal test readings shown apply with the ignition switched ON unless otherwise stated.

First check that the control module has a power supply and is grounded.

Then check all sensor inputs and signals from other systems.

Finally, check the outputs. Remember that the test readings do not tell us whether or not the module is functioning properly.

If any reading is not OK, consult the wiring diagram to trace the leads, connectors or components which should be checked more thoroughly.

The specified test readings refer to those obtained with a calibrated Fluke 88/97.

Test readings % (+) and ms (+) show the pulse ratio and pulse duration of the signal. The test instrument used must be able to measure pulse ratio and pulse width. The (+) sign denotes a positive trigger pulse, TRIG+.



Connections, head unit

> = greater than; < = less than; ~ = AC voltage (LP: LOGIC PROBE P = select pulse; p = visible pulses)

K14


Pin No.

Component/

Function

In/Out

Test conditions

Across

Test value

See

1

Power supply +30:

In



1-8

B+





2

Line output, front left (+)

Out

Music playing

2-8

Radio system 1: Normal sound level, ∼0-2 VAC. Max. volume, ∼0-10 VAC.

Radio system 2 and 3: Max. volume ∼2-3 VAC.

The test reading should vary with the volume of the music.



3

Line output, front right (+)

Out

Music playing

3-10

Radio system 1: Normal sound level, ∼0-2 VAC. Max. volume, ∼0-10 VAC.

Radio system 2 and 3: Max. volume ∼2-3 VAC.

The test reading should vary with the volume of the music.



4

Phone line input, signal

In

Call active

4-5

∼0-300 mVAC

Telephone system



5

Phone line input, ground

In

Call active

4-5

∼0-300 mVAC

Telephone system



6

Trigger voltage, amplifier

Out

Radio switched on

6-8

B+



7

No connection











8

Ground:

In



1-8

B+



9

Line output, front left (-)

Out

Music playing

3-9

Radio system 1: Normal sound level, ∼0-2 VAC. Max. volume, ∼0-10 VAC.

Radio system 2 and 3: Max. volume ∼2-3 VAC.

The test reading should vary with the volume of the music.



10

Line output, front right (-)

Out

Music playing

3-10

Radio system 1: Normal sound level, ∼0-2 VAC. Max. volume, ∼0-10 VAC.

Radio system 2 and 3: Max. volume ∼2-3 VAC.

The test reading should vary with the volume of the music.



11

No connection











12

Trigger voltage antenna

Out

Main unit on

12-8

B+



13

I-bus (1-lead)

In/Out

Ignition ON

13-8

2-3 V



14

No connection













K16


Pin No.

Component/

Function

In/Out

Test conditions

Across

Test value

See

1

Line input satellite radio receiver Right (+)

In

Music playing

1-9

0-2 V AC. The test reading should vary with the volume of the music.



2

Line input satellite radio receiver Right (+)

In

Music playing

2-10

0-2 V AC. The test reading should vary with the volume of the music.



3

No connection











4

Telephone mute

In

No telephone call

4-8 in K14

5 V

Telephone system









Telephone call

4-8 in K14

<2 V



5

Line output, rear left (+)

Out

Music playing

5-13

Radio system 1: Normal sound level, ∼0-2 VAC. Max. volume, ∼0-10 VAC.

Radio system 2 and 3: Max. volume ∼2-3 VAC.

The test reading should vary with the volume of the music.



6

Line output, rear right (+)

Out

Music playing

6-14

Radio system 1: Normal sound level, ∼0-2 VAC. Max. volume, ∼0-10 VAC.

Radio system 2 and 3: Max. volume ∼2-3 VAC.

The test reading should vary with the volume of the music.



7

No connection











8

Mute control, amplifier

Out

The ignition is switched on

8-8 in K14

<1 V after approx. 1 sec. B+ for approx. 10 sec.









The ignition is switched off

8-8 in K14





9

Line input satellite radio receiver Left (-)

In

Music playing

1-9

0-2 V AC. The test reading should vary with the volume of the music.



10

Line input satellite radio receiver Right (-)

In

Music playing

2-10

0-2 V AC. The test reading should vary with the volume of the music.



11

No connection











12

No connection











13

Line output, rear left (-)

Out

Music playing

8-13

0-2 V AC. Dependent on volume control. The test reading should vary with the volume of the music.



14

Line output, rear right (-)

Out

Music playing

6-14

0-2 V AC. Dependent on volume control. The test reading should vary with the volume of the music.



15

No connection











16

No connection













PRE-RELEASE