PRE-RELEASE
Headlamps, programming
| Headlamps, programming |
| Important | ||
|
Switching between main and dipped beams is only possible with the light switch in position 2. Applies to all alternatives. |
||
|
The fuse 35 has been removed from cars on markets where daylight driving lights are not used. Program alternatives 1 and 2. |
||
|
While the engine is being started, the dipped beam is turned off. This is irrespective of the program alternative if the light switch is in position 0 or 1, but for safety reasons it is maximized to 20 seconds. |
||
Alternative 1
When the light switch (10) is in position 0 or 1, none of the main lighting should be active.
In position 0, none of the position lights should be active. (Germany + other markets).
Alternative 2
When the light switch is in position 0, dipped beams should be on (daylight driving lights).
In position 0 it is not possible to switch between main and dipped beams (Sweden).
Alternative 3
When the light switch is in position 0 or 1, the dipped beams should be on.
In position 0 or 1 it is not possible to switch between main and dipped beams (Canada).
| Programming, parking lights |
Acoustic warning (yes/no)
Pre-programmed: yes
