PRE-RELEASE
Range sensor (SPA), 4D
| Range sensor (SPA), 4D |
| Removal |
| 1. |
Remove
Bumper shell/cellular block, rear 4D.
|
|
| 2. |
Unplug the connector from the sensor.
|
|
| 3. |
Detach the sensor from the holder.
|
|
| Refitting |
When being replaced, the visible parts of the range sensors and holders must be painted in the same colour as the bumper shell.
| Important | ||
|
The paint layer must not be thicker than 90μ. Otherwise, the function of the system could be affected. |
||
| 1. |
Plug in the connector to the sensor.
|
|
| 2. |
Fit the sensor into the holder. Make sure the guide pin is in the correct position.
|
|
| 3. |
Fit
Bumper shell/cellular block, rear 4D.
|
|
| Changing holder |
| 1. |
Push in the snap fastener and remove the holder from the bumper shell.
|
|
| 2. |
Push the new holder securely into place. Check that the holder correctly locates in the cut-out in the bumper shell.
|
|
