PRE-RELEASE
Input shaft speed sensor
| Input shaft speed sensor |
| To remove |
| 1. |
Remove the battery cover and the battery.
|
|
| 2. |
Remove the MAXI fuse holder from the battery tray and place it to one side. Remove the battery tray.
|
|
| 3. |
Undo the battery cable bracket.
|
|
| 4. |
Clean the area round the sensor. Remove the sensor's retaining bolt.
|
|
| 5. |
Remove the sensor.
|
|
| 6. |
Unplug the connector.
|
|
| Fitting |
| 1. |
Plug in the sensor's connector.
|
|
| 2. |
Fit the sensor in place.
|
|
| 3. |
Tighten the sensor's retaining bolt.
Tightening torque: 6 Nm (4.5 lbf ft) |
|
| 4. |
Fit the battery cable bracket.
|
|
| 5. |
Fit the battery tray, MAXI fuse board, battery and battery cover.
|
|
| 6. |
Set the right time on the clock.
|
|
