PRE-RELEASE
Lower fluid delivery pipe (4-cyl)
| Lower fluid delivery pipe (4-cyl) |
| 1. |
Raise the car.
|
|
| 2. |
Place an oil pan under the transmission to collect fluid spill.
|
|
| 3. |
Remove the banjo screw for the return line and plug the hole. Use e.g. plug, part no. 91 32 929, and seal, part no. 91 32 937.
|
|
| 4. |
Lower the car to the floor.
|
|
| 5. |
Remove the pipes' bracket from the fan cowling.
|
|
| 6. |
Remove the bypass pipe and valve.
Remove the upper banjo bolt. |
|
| 7. |
Unplug the connectors from the radiator fans. Undo the clip securing the hose to the expansion tank. Remove the screws and lift out the complete fan cowling.
|
|
| 8. |
Remove the lower banjo bolt.
|
|
| 9. |
Lift away the return pipe.
|
|
| Fitting |
| Note | ||
|
Change the seals in the banjo bolts. |
| 1. |
Place the return pipe in its correct position.
|
|
| 2. |
Fit the banjo bolt but do not tighten it.
|
|
| 3. |
Fit the fan cowling and tighten the screws.
|
|
| 4. |
Plug in the connectors to the radiator fans. Fit the clips securing the hose to the expansion tank. Fit the upper banjo nipple loosely.
|
|
| 5. |
Fit the fasteners to the fan cowling and tighten them. Tighten the upper and lower banjo screws.
Tightening torque 24 Nm (18 lbf ft) 
|
|
| 6. |
Fit the bypass pipe and valve.
|
|
| 7. |
Raise the car.
|
|
| 8. |
Fit the banjo bolt on the transmission and tighten it.
Tightening torque 24 Nm (18 lbf ft) |
|
| 9. |
Lower the car to the floor.
|
|
| 10. |
Fill with transmission fluid to the correct level. See
Automatic transmission, fluid level
.
|
|
