PRE-RELEASE
Gear lever housing
| Gear lever housing |
| 1. |
Remove the centre console as described in group 8 "Body, Interior equipment".
|
|
| 2. |
Engage 4th gear and secure 4th in the gearbox with
87 92 335 Locking pin
.
|
|
| 3. |
Undo the pinch-bolt clamp to the selector rod universal joint.
|
|
| 4. |
Remove the bolts securing the gear lever housing.
|
|
| 5. |
Lift the gear lever housing and unplug the electrical connection to the ignition switch.
|
|
| 6. |
Lift out the gear lever housing.
|
|
| To fit |
| 1. |
Insert the end of the selector rod through the rubber gaiter. Put the gear lever housing in place in the car.
|
|
| 2. |
Plug in the electrical connection to the ignition switch and fit the cable entry into the gear lever housing.
|
|
| 3. |
Fit the air duct before bolting down the gear lever housing.
|
|
| 4. |
Tighten the gear lever housing (4 bolts). Note that there are 2 guide pins on the gear lever housing.
Tightening torque 8 Nm (6 lbf ft) |
|
| 5. |
Engage 4th gear and insert locking pin 87 92 632
into the gear lever housing.
|
|
| 6. |
Tighten the pinch-bolt clamp at the gear linkage in the engine bay.
Tightening torque: 22 Nm (16 lbf ft). |
|
| 7. |
Remove the locking pin from the gearbox and gear lever housing. Fit the plug on the gearbox.
|
|
| 8. |
Check that all gears can be engaged and that the key can be removed in reverse.
|
|
| 9. |
Fit the centre console as described in group 8 "Body, Interior equipment".
|
|
