PRE-RELEASE
Rear spoiler, 5D
| Rear spoiler, 5D |
| 1. |
Open the tailgate
|
|
| 2. |
Remove the top cover on the inside of the tailgate.
|
|
| 3. |
Remove the 2 rubber plugs.
|
|
| 4. |
Remove the centre brake light.
|
|
| 5. |
Remove the screws securing the spoiler.
|
|
| 6. |
Close the tailgate.
Remove the centre nut. The nut can be reached through the space left by the brake light. |
|
| 7. |
Carefully lift off the spoiler.
|
|
| To fit |
| 1. |
Clean off any residue from seals and double-sided adhesive tape with benzine or equivalent.
|
|
| 2. |
Clean under the spoiler mounting points and the surfaces on the tailgate on which the spoiler is to be fitted.
|
|
| 3. |
Fit new seals and affix the double-sided adhesive tape under the centre mounting point on the spoiler, see illustration.
|
|
| 4. |
Remove the backing from the double-sided adhesive tape and position the spoiler correctly, starting from the rear edge.
Press on the front of the spoiler and press for at least 1 minute on the front centre mounting point to allow the tape to adhere properly. |
||||||||||
| 5. |
Fit the centre nut, without tightening it, through the space left by the brake light.
|
|
| 6. |
Open the tailgate and insert the screws.
|
|
| 7. |
Tighten the nut on the centre spoiler mounting point first and then the screws on the outer mounting points.
Make sure the clearance between the tailgate and the spoiler mounting points is satisfactory. |
|
| 8. |
Fit the centre brake light.
|
|
| 9. |
Fit the rubber plugs.
|
|
| 10. |
Fit the cover on the inside of the tailgate. Close the tailgate.
|
|
