SAAB WIS ONLINE

PRE-RELEASE

Crankshaft position sensor (345)

Crankshaft position sensor (345)

To remove


1. Raise the car. Remove the lower engine cover.


2. Unplug the position sensor connector.


Important

Take care when releasing the locking mechanism on the connector so as not to damage the connector. Pull the halves straight apart to avoid bending the pins. For further information regarding connectors, refer to Connectors, handling and inspection .


3. Remove the position sensor.


To fit


1. Grease the position sensor O-ring with acid-free Vaseline and fit it. Take care not to damage the O-ring.

2. Fit the position sensor.

Tightening torque: 9 Nm (7 lbf ft)


3. Plug in the position sensor.

Important

Take care when plugging in the connector so as not to damage or press out the pins/sleeves in the connector. For further information regarding connectors, refer to Connectors, handling and inspection .


4. Fit the lower engine cover. Lower the car.


5. Connect an exhaust extraction hose and start the engine. Check for oil leaks.


PRE-RELEASE