PRE-RELEASE
No contact with any bus system
Read the instructions below then start the fault diagnostic procedure.
Symptom: The text on the diagnostic tool's display reads: “No contact with any bus system”. “Cause: no communication with DICE”.
| No contact with any bus system |
Fault symptoms
The text on the diagnostic tool's display reads: “No contact with any bus system”. “Cause: no communication with DICE”.Condition
The following conditions are applicable:| • |
Ignition switch in ON position
|
|
Diagnostic help
First check the fuses for the DICE control module and make sure no slide-out has occurred of the data link connector pins for communication with the DICE.Then check whether the DICE is awake and allows diagnostics communication. If this is the case, check whether the diagnostics tool works on another car.
If no fault can be found, repair or replace the communication lead between the DICE and the data link connector.
