PRE-RELEASE
The diagnostic tool display shows "MISSING" for one or more systems.
Read the instructions below then start the fault diagnostic procedure.
Symptom: The word “MISSING” flashes on the diagnostic tool display for one or more systems.
| The diagnostic tool display shows "MISSING" for one or more systems. |
Fault symptoms
The word “MISSING” flashes on the diagnostic tool display for one or more systems.Condition
The following conditions are applicable:| • |
Ignition switch in ON position
|
|
Diagnostic help
If all systems (except the DICE) are missing, check the I-bus for an open circuit at the DICE or a short circuit anywhere at all in the wiring. Use the NIGHT PANEL button to distinguish between the two types of fault.If one or more systems are missing, check whether the control modules are awake and allow diagnostics communication. If this is the case, study the wiring diagram to find out exactly where in the bus network the fault is located on the basis of which system or systems are missing.
The potential between bus+ and ground and between bus- and ground should be 2- 3 V. All control modules put out this voltage.
The diagnostic tool main menu “All systems/Read configuration” shows a list of the systems fitted to the car as original equipment.
“OK” will be shown to the right of each system if the system is communicating correctly or “MISSING” if the system is missing from the bus.
If a new control module is installed in the car, it will automatically be included on the list.
If a control module for the CD changer or radio, for instance, is removed from the car, the list can be reset to zero with the command under “All systems/Read configuration/Clear”.
