Automatic transmission, transmission fluid level without dipstick
|
|
Automatic transmission, transmission fluid level without dipstick
|
Warning
|
|
Hold the footbrake depressed.
|
|
|
|
|
|
|
1.
|
Park the car on level ground and apply the handbrake.
|
|
2.
|
Start the engine and allow it to idle. Select position D and wait for at least 15 seconds. Then select R and wait for 15 seconds. Repeat for position P.
|
|
3.
|
Connect the diagnostic tool and run the engine until it reaches 80°C as per the "Read values" menu for TCM.
|
Warning
|
|
Risk for burn injuries when working on the catalytic converter.
|
|
|
|
|
|
|
|
4.
|
Remove the plug using 30 16 516 Torx sleeve. Use butyl tape or the like to secure the plug on the tool.
|
|
5.
|
Check the fluid level using
DT-47653 Gauge rod
. (engine idling and selector lever in P). Fill with fluid as necessary using
87 92 822 Oil filling equipment
. Pay attention to the appearance and odour of the fluid. If the fluid is cloudy/discoloured and/or smells burnt it must be changed even if there is no noticeable reduction in shift quality or noise. See
Changing the automatic transmission fluid
.
|
Important
|
|
Fill up with oil through the dipstick hole. Do not remove any other plugs from the top of the gearbox.
|
|
|
|
Important
|
|
The dipstick has only one measuring range for warm oil. The oil volume between min-max is 0.5 litres (0.5 qts).
|
|
|
|
|
6.
|
Fit the plug
Tightening torque 30 Nm (22 lbf ft)
|
See
Weight, fluid capacity and grade of fluid
