PRE-RELEASE
Torque converter seal
| Torque converter seal |
| To remove |
| 1. |
Remove the transmission, see Complete transmission.
|
|
| 2. |
Lift out the torque converter.
|
|
| 3. |
Insert
Puller, torque converter seal
87 92 384 inside the seal and use
83 90 270 Sliding hammer
to loosen the seal.
|
|
| Fitting |
| 1. |
Fit the new seal using
sleeve, driver shaft bearing
87 91 311.
|
|
| 2. |
Position the torque converter.
|
|
| 3. |
Check that the torque converter is correctly positioned by placing a steel rule on the torque converter housing's mating surface and measuring the distance between the mating surface and the drive plate's contact surface on the torque converter.
The distance should be: min. 9 mm. |
|
| 4. |
Fit the transmission, see Complete transmission.
|
|
