PRE-RELEASE
Ignition switch with connector
| Ignition switch with connector |
| 1. |
Remove the gear lever housing, see
.
|
|
| 2. |
Remove the lock plate holder.
|
|
| 3. |
Remove the spring securing the lock plate.
|
|
| 4. |
Use a screwdriver to unclip the pawl which is controlled by the ignition switch. Lift the lock plate with its bracket.
|
|
| 5. |
Remove the ignition switch connector.
|
|
| 6. |
Remove the ignition switch.
|
|
| To fit |
| 1. |
Fit the ignition switch.
|
|
| 2. |
Fit the ignition switch connector.
|
|
| 3. |
Insert the lock plate. Check that the lock plate's 2 mountings (rubber bushes and cones) in the housing are in place.
|
|
| 4. |
Snap the ignition switch pawl into the lock plate.
|
|
| 5. |
Put the lock plate bracket in place. Apply Loctite 242, part no. 74 96 268, to the bolts holding the lock plate bracket.
|
|
| 6. |
Fit the lock plate spring.
|
|
| 7. |
Adjust the position of the lock plate with the screw on the lock plate holder so that it is level with the lug in the gear lever housing.
|
||||||||||
| 8. |
Fit the gear lever housing as described in
.
|
|
