PRE-RELEASE
Wheel sensor, front right
| Wheel sensor, front right |
| 1. |
Remove the oil reservoir. Leave the hoses in place.
|
|
| 2. |
Depress the locking tab on the connector and remove it from the holder.
Unplug the connector. |
|
| 3. |
Raise the car and remove the wheel.
Clean the area round the wheel sensor using a soft wire brush. |
|
| 4. |
Undo the wheel sensor retaining bolt and remove the wheel sensor.
|
|
| 5. |
Remove the grommet and withdraw the lead.
|
|
| 6. |
Detach the lead from the clips and lift out the sensor.
|
|
| To fit |
| 1. |
Fit the wheel sensor in its holder and tighten the retaining bolt.
|
|
| 2. |
Insert the lead.
|
|
| 3. |
Press the lead into the clips and fit the grommet.
|
|
| 4. |
Fit the wheel and lower the car. See
Wheels
.
Tightening torques aluminium wheel 110 Nm (81 lbf ft) steel wheel 50 Nm +2x90°, max. 110 Nm (37 lbf ft +2x90°, max. 81 lbf ft) |
|
| 5. |
Connect the lead and fit the connector into the holder.
|
|
| 6. |
Fit the oil reservoir.
|
|
