SAAB WIS ONLINE

PRE-RELEASE

Airbag, passenger

Airbag, passenger

Warning

Read through carefully before starting work.


To remove



1. Ignition switch in the OFF position.

Warning

The battery's ground cable must be removed before the positive cable. Wait for at least 1 minute after disconnecting the battery before beginning any work on the airbag system. Otherwise the airbag may be deployed unintentionally and this can cause fatal/severe personal injuries.


2. Remove the dashboard. See To remove .

3. Unscrew the passenger airbag from the dashboard, 6 nuts.

4. Lift out the airbag.

5. Remove the wiring harness from the airbag.


To fit



1. Connect and mount the wiring harness to the airbag.

2. Screw the airbag to the dashboard, 6 nuts.

3. Fit the dashboard. See To fit .


Note

In SE and FI markets, transfer or replace the warning label on the dashboard.


4. Turn on the ignition and check the SRS system and control module with the diagnostic tool as follows:

Connect the diagnostic tool to the diagnostic socket under the dashboard. Delete any trouble codes.

Switch off the ignition and switch it on again. Wait at least 10 minutes with the ignition switched on.

Check whether a diagnostic trouble code is displayed:

If a diagnostic trouble code is displayed:

Carry out fault diagnosis in accordance with the directions given for each DTC.

If no diagnostic trouble code is displayed:

Disconnect the diagnostic tool.


PRE-RELEASE