PRE-RELEASE
Boot lid 4D
| Boot lid 4D |
| 1. |
Open the boot lid.
|
|
| 2. |
Open the hatch in the trim in front of the left-hand rear lamp and unplug the connector to the boot lid wiring harness.
|
|
| 3. |
Remove the grommet hose from the body and unfasten it from the hinge.
|
|
| 4. |
Remove the clip securing the gas spring to the ball joint.
|
|
| 5. |
Remove the gas spring from the hinge.
|
|
| 6. |
Remove the two lower nuts holding the lid to the hinge
|
|
| 7. |
Unscrew the two top nuts a few turns.
|
|
| 8. |
Carefully lift off the boot lid.
|
|
| To fit |
| 1. |
Put the boot lid on its hinges.
|
|
| 2. |
Screw on the nuts.
|
|
| 3. |
Fit the gas springs to the hinges and fit the clips.
|
|
| 4. |
Insert the wiring harness through the grommet hose and attach the hose to the hinge.
|
|
| 5. |
Plug in the connector.
|
|
| 6. |
Check the fit of the lid and adjust if necessary, see
.
|
|
