PRE-RELEASE
Rear door handle
| Rear door handle |
| 1. |
Open the door.
|
|
| 2. |
Remove the cover around the window frame.
|
|
| 3. |
Remove the door trim.
|
|
| 4. |
Remove the water separator using
82 93 474 Removal tool
.
|
|
| 5. |
Remove the nuts and plate from the back of the handle.
|
|
| 6. |
Remove the three screws holding the lock unit.
|
|
| 7. |
Lower the lock unit slightly so that the push rod falls out.
|
|
| 8. |
Lift out the handle.
|
|
| Fitting |
| 1. |
Put the handle in place.
|
|
| 2. |
Fit the plate and tighten the handle nuts.
|
|
| 3. |
Guide the push rod into the lock unit and position it in the door.
|
|
| 4. |
Screw on the lock unit.
|
|
| 5. |
Refit the water separator, door trim and cover around the window frame.
|
|
