PRE-RELEASE
Ventilation fan control
| Ventilation fan control |
| To remove |
| 1. |
Drape protective covers over the front wings.
|
|
| 2. |
Remove the wiper arms with
85 80 144 Puller, windscreen wiper arm
.
|
|
| 3. |
Remove the rubber seals on the wiper spindles.
|
|
| 4. |
Remove the rubber moulding along the edge of the bulkhead and loosen the clips on one side. Place the rubber moulding on one side.
|
|
| 5. |
Loosen the cover over the bulkhead partition space (fastened with clips) by lifting it carefully forwards so that it is released from the windscreen.
|
|
| 6. |
LHD
: Move aside the bonnet cable and lift the cover backwards towards the windscreen.
|
|||||||
| 7. |
Loosen the clips holding the front edge of the water shield with a screwdriver. Lift off the water shield.
|
|
| 8. |
RHD
: Remove the wiper assembly and unplug the connector.
|
|
| 9. |
Free the wiring harness over the ventilation fan (fastened with clips).
|
|
| 10. |
Cut off the cable tie
(RHD)
and undo the connector to the ventilation fan. Detach the connector from the cover and extract it. (Illustration shows RHD.)
|
|
| 11. |
Press down the wiring harness, including the rubber seal, to the control unit.
|
|
| 12. |
Remove the
Glove box
.
|
|
| 13. |
Unplug and detach the connector from the bracket.
|
|
| 14. |
Unscrew the control unit from the fresh-air filter cover.
|
|
| To fit |
| 1. |
Fit the control unit to the fresh-air filter cover.
|
|
| 2. |
Fit the connector to the bracket and plug it in.
|
|
| 3. |
Lift up the cable and fit the rubber seal.
|
|
| 4. |
Refit the
Glove box
.
|
|
| 5. |
Insert the wiring harness to the ventilation fan through the protective cover. Observe the foam seal in the hole.
|
|
| 6. |
Plug in the connector and fit a new cable tie
(RHD)
to the ventilation fan. Check that the wiring harness does not touch the fan motor. (Illustration shows RHD.)
|
|
| 7. |
RHD
: Fit the wiper assembly and connector, 4 bolts.
|
|
| 8. |
Put back the water shield (fastened with 3 clips on front edge).
|
|
| 9. |
Lift in the cover over the bulkhead partition space from behind, towards the windscreen.
LHD : Move the bonnet cable to the side and then fit it in its groove. 
|
|
| 10. |
Fit the rubber moulding on the front of the bulkhead, 2 clips.
|
|
| 11. |
Fit the rubber seals on the wiper spindles.
|
|
| 12. |
Fit the wiper arms.
|
|
| 13. |
Remove the protective covers from the front wings.
|
|
