PRE-RELEASE

Camshaft Cover Assemble

•

EN-49412 Oil Seal Installer

•

EN-49417 Bearing and Seal Driver

For equivalent regional tools, refer to Special Tools .

Left Camshaft Cover

Install the NEW left spark plug shield tube seals using the EN-49412 installer (1) and EN-49417 driver (2).

Install the NEW left camshaft cover gasket.

Install the oil filler cap.

Install the fuel injector sight shield cover ball stud.

Refer to Fastener Caution .

Tighten the fuel injector sight shield cove ball stud to 10 Nm (89 lb in) .

Note
The camshaft cover bolt insulator must be installed into the camshaft cover bolt hole before installing the camshaft cover bolt.

Install the NEW left camshaft cover bolt insulators.

Right Camshaft Cover

Install the NEW right spark plug shield tube coil seals using the EN-49412 installer (1) and EN-49417 driver (2).

Install the NEW right camshaft cover gasket.

Note
The camshaft cover bolt insulator must be installed into the camshaft cover bolt hole before installing the camshaft cover bolt.

Install the NEW right camshaft cover bolt insulators.