Crankshaft Balancer Installation
|
|
Crankshaft Balancer Installation
|
Special Tools
|
•
|
EN 47981
Crankshaft Balancer Holding Tool
|
|
•
|
EN 956 1
Tool Extension
|
|
•
|
EN 41998 B
Crankshaft Balancer Installer
|
|
•
|
EN 45059
Torque Angle Sensor Kit
|
For equivalent regional tools, refer to
Special Tools
.
|
1.
|
Place the crankshaft balancer in position on the crankshaft.
|
|
2.
|
Thread the
EN 41998 B
installer in the crankshaft. Ensure you engage at least 10 threads of the
EN 41998 B
installer before pressing the crankshaft balancer in place.
|
|
3.
|
Push the crankshaft balancer into position by tightening the nut on the
EN 41998 B
installer until the large washer bottoms out on the crankshaft end.
|
|
4.
|
Remove the
EN 41998 B
installer.
|
|
5.
|
Install the
EN 47981
holder (1) with
EN 956 1
extension (2) to crankshaft balancer.
|
|
6.
|
Refer to
Fastener Caution
.
Install the crankshaft balancer bolt (3) and tighten in first pass to
100 Nm (22 lb ft)
.
|
|
7.
|
Tighten the crankshaft balancer bolt a second pass to
150 degrees
using the
EN 45059
sensor kit.
|
