PRE-RELEASE
Crankshaft Rear Oil Seal and Housing Installation
| Crankshaft Rear Oil Seal and Housing Installation |
Special Tools
| • |
EN 47839
Crankshaft Rear Oil Seal Installation Tool
|
|
| • |
EN 42183
Handle
|
|
For equivalent regional tools, refer to Special Tools .
| 1. |
Place a 3 mm (0.118 in) bead of RTV sealant to the oil pan as shown. Refer to
Adhesives, Fluids, Lubricants, and Sealers
for the recommended sealant.
|
|
| 2. |
Place a 3 mm (0.118 in) bead of RTV sealant to the NEW crankshaft rear oil seal housing as shown (1). Refer to
Adhesives, Fluids, Lubricants, and Sealers
for the recommended sealant.
|
|
| 3. |
Install the
EN 47839
installer with the
EN 42183
handle (1, 2) onto the rear of the crankshaft flange.
|
|
| 4. |
Install the 2 bolts (3).
|
|
| 5. |
Install the crankshaft rear oil seal housing (2) to the engine block. 
|
|||||||
| 6. |
Install the 5 crankshaft rear oil seal housing bolts (2).
|
|
| 7. |
Refer to
Fastener Caution
.
Tighten the 5 crankshaft rear oil seal housing bolts in sequence as shown to 10 Nm (89 lb in) . 
|
|
| 8. |
Tighten the 2 oil sump bolts to
10 Nm (89 lb in)
.
|
|
| 9. |
Remove the 2 bolts (3).
|
|
| 10. |
Remove the
EN 47839
installer and
EN 42183
handle (1, 2) from the crankshaft flange.
|
|
